If you've got hardwood floors, too much water can spell disaster. Unfortunately, you can't control the water when a pipe bursts, which is quite common during the winter. If your pipes burst this winter, you'll need to act fast to save your hardwood floors, especially if you want to avoid water damage. Use the instructions provided below to get rid of the water and save your hardwood floors.
Clear the Room Out
Once you've got standing water on your hardwood floor, you'll need to clear the room out. You're going to need full access to your flooring, so don't leave anything in the room. Not only that, but leaving anything on your hardwood flooring while it's wet could lead to permanent damage, include set-in water marks. Removing everything from the room will give you space to work, and it will prevent water marks.
Remove the Water
After you've cleared the room, you'll need to start removing the water. In most cases, you'll be able to use ordinary shop vacuums. However, if you've got a large area that's covered with water, or if the water is more than an inch or two deep, you're going to need a sump pump. If you do end up using a sump pump, remove the bulk of the water with the pump, and then go over it again with the shop vacuum to remove all the residual moisture.
Clean the Floor Thoroughly
Once you've successfully cleared the room and removed the water, you'll need to give your wood flooring a deep cleaning. Cleaning the wood will remove the dirt and sand that might have been tracked in with the water. Fill a bucket with warm water and add about a cap full of disinfectant liquid cleaner. Mop the entire floor and then use your shop vacuum to remove the excess water. If the floor still has a grungy, dull appearance, go ahead and give it one more cleaning with the disinfectant cleaning solution. Be sure to use your shop vacuum to remove the excess water each time you mop.
Bring in the Dehumidifiers and Fans
Once your hardwood floor has been exposed to flood waters, you'll need to make sure that the wood is dry all the way through to the underside. The best way to do that is with dehumidifiers and fans. For a small room, you can use one dehumidifier and one fan. However, if you're drying out a larger room, you should bring in additional units.
Don't let a broken pipe destroy your new hardwood floors. The care instructions provided here will help you remove the water and prevent lasting damage. If your floor does end up stained or discolored, reach out to a company like Rocky Mountain Hardwood to discuss your replacement options.